Jacuzzi J - 470 Manuel d'utilisateur télécharger pdf (Page 22)

Page 16

J-400 Series

7.0 Power Requirements

Jacuzzi

spas are designed to provide optimum performance and

exibility of use when connected to their maximum electrical service.

They are congured at the factory. The most common electrical

connections are listed below:

All North American 60 Hz Models only: These models come set for

50A logic. If you prefer, your qualied technician can perform a logic

modication that allows the spas to operate on a different electrical

service (see table footnotes below).

North American J-460/J-465/J-470/J-480 Models (60 Hz)

Voltage: 240 VAC 240 VAC 240 VAC

Max. Current Draw: 23A 36A 45A

Frequency: 60 Hz 60 Hz 60 Hz

Number of Wires: 3 3 3

Circuit Breaker (2-Pole): 30A* 50A** 60A***

In 30A conguration, the heater will not operate while either jets

pump is running.

In 50A conguration, the heater will not operate while both jet

pumps are running. This is the factory setting.

***

In 60A conguration the heater will operate while both jet pumps

are running.

All Export 50 Hz Models: These models have two terminals

requiring 2 circuit breakers and only have one logic option available.

Export J-460/J-465/J-470/J-480 Models (50 Hz)

Main

Terminal Breaker*

Heater

Terminal Breaker**

Voltage: 230 VAC 230 VAC

Max. Current Draw: 16.6A 12A

Wattage 3.8 kW 2.6 kW

Frequency: 50 Hz 50 Hz

Number of Wires: 3 3

The main terminal breaker is solely for the pumps, circulation

pump, ozone, stereo option (if installed) and accessories.

The heater breaker is solely for the heater, to allow the heater to

operate while both jet pumps are running.

Note: Two breakers needed see Figure E page 14.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 103 104

Pas de commentaire

Jacuzzi J - 470 Manuel d'utilisateur Page 22